|
|
|
M.P.Innovations
Whale Watermaster Pump lock |
Caravan Advice - DIY - Feedback - Handy Hints - Maintenance - Miscellaneous - Your Questions |
|
Parts: |
- 1 split pin
- 1 M8 x 70mm Raw Bolt
- 1 Nut
- 3 washers
- 1 L shaped bracket
|
Take the M8 raw plug and add washer 1. Push the raw bolt through the shaped recess that holds the pump at rest. Insert washer 2, then bracket then washer 3 and then add the nut and tighten up to finger pressure only. Put the split pin through the nut and secure. Use a rope type lock through the open hole in the bracket to secure to the caravan chassis.
|
|
Parts: |
1 x 10swg metal x 168mm x 25mm |
Take the length of 25mm x 168mm x 10 swg metal and bend to required measurement as above.
Drill 7.5mm hole for lock.
When finished lift up the 25mm section enough to enter the pump pipe behind the van socket. Close with a vice until secure.
The hose fitting is then secured to the caravan chassis using a rope type cycle lock. |
|
Another great Idea from M.P.Innovations |
Download a copy of MP Inovations Whale Pump Lock for personal use only. |
Copyright©2008Michael Parkes MP Inovations All rights reserved!. |
Caravan Advice - DIY - Feedback - Handy Hints - Maintenance - Miscellaneous - Your Questions |
|
|
|
|
|
|
|
|
|
|
|
Copyright © 1998 - 2015 Thomson T-Line History & Information |
|
|
Disclaimer - The information provided on this Website site is offered with no warranty as to the authenticity, suitability or competence of the individual, company or service quoted here in. The Website shall not be liable for any damage or difficulty, direct or indirect, arising from utilization of the information contained within these pages. Thomson T-Line History & Information is not responsible for the content of external website's. |
|
|